More
CDN 405T8 (POE 10KV) coupling/decoupling network is suitable for (surge test) 4 pairs of 8-wire unshielded symmetric high speed (POE)
The WCT 20 is used in conducted, differential mode current test as per IEC 61000-4-19.
Low-k dielectric material for laboratory test adopts material with dielectric constant (εr) less than or equal to 1.4.
The INS 800 high frequency noise simulator is designed to simulate the interference caused by the rapid breaking of the current through the inductive component represented by the relay on or off.
The line impedance stabilization network LISN AR 50 is designed as per section 20 and 22 in RTCA / DO 160 and used to standardize the impedance of the power source that provides input power for the EUT(s).
The wide-band current monitor CM 0301M is used for measuring alternating current and time domain pulse current in the frequency range from 10 Hz to 1 MHz.
The CDN 419M3-32 is designed in accordance with IEC610000-4-19:2014 and applicable to immunity to conducted
The electrostatic sensitivity tester for electric initiating explosive device EDS 30S is designed according to GJB 736.11:1990, which is used to measure the relative sensitivity of electric initiating explosive device to electrostatic spark discharge so as to determine its safety.
The combination wave surge generator CWS 20G is designed according to IEC/EN 61000-4-5, IEC 60950, IEC 62305-4, IEC 61643-1, ITU-T K17, ITU-T K21 and customer’s requirement.
The line impedance stabilization network LISN ML500HVS is designed as per GJB151B and MIL-STD-461 and used for isolating power interference and provide specified power impedance for EUT
Youtube
Facebook
Twitter
