Technical Parameters

Test Voltage Range

0.25 kV ~ 4.2 kV ± 10%(Calibration voltage: 500 V ~ 4.0 kV)

Polarity

Positive and negative

Source Impedance

50 Ω ± 20%

Voltage Wave Rise Time

5 ns ± 30%

Frequency

3 MHz / 10 MHz / 30 MHz  ± 10%

Decay

PK5＞PK1的50%
PK10＜PK1的50%

Repetitive Frequency

5 kHz ±10%

Repetitions

Maximum 999,9

Pulse Train Duration

3 MHz＜330 ns
10 MHz＜100 ns
30 MHz＜33 ns

Group Cycle

300 ms±20%

Short-Circuit Current

5 A ~ 80 A ±20%(Calibration current: 10 A ~ 80 A)

Current Wave Rise Time

3 MHz＜330 ns
10 MHz＜100 ns
30 MHz＜33 ns

Decay

Pk5>25% of Pk1
Pk10<25% of Pk1

Trigger Mode

Automatic, manual, external triggering

Coupling Network

Built in high-power three-phase DC automatic coupling/decoupling network
EUT load capacity   AC 1000 V 100 A
                                   DC 1500 V 100 A

Residual surge voltage at decoupling network power port

Not exceeding 15% of the applied test pulse voltage or twice
the peak rated voltage of the coupling/decoupling network

General Parameters

Scope of Working PowerSupply

AC 220 V ±10%，50 Hz /60 Hz ±5%

Fuse

6A

Use Ftorage Space

Infinite (PC)

Communication Method

Ethernet LAN, RJ45

Instrument Weight

About 145 kg

Safety Circuit

Stop working when the safety circuit is not closed

Failure Detection

When it fails, the front panel LCD displays and interrupts the instrument operation

Instrument Working Status Indicator

Front panel LED indicator, LCD display

Instrument Grounding Connection Method

Use a flat grounding wire

Chassis Size

19 inches / 22U 600 mm (W) * 1145 mm (H) * 800 mm (D)

Temperature Range

15 ℃ ~ 35 ℃

Humidity Range

45% ~ 75% RH(No condensation)

Compressed Air

86 kPa ~ 106 kPa

Standard Accessories

Power cord, Fuse, test wire, Grounding wire, RF cable, Instruction manual, Quality
inspection report, Product warranty certificate, Pulse group single channel testing fixture

Optional Accessories

1

Splitter

0.1 V/A Model: MCS 01B

2

Pulse Group Calibration Kit

Model: EFT-CA-KIT(SHV)
EFT attenuator, meeting pulse group
calibration requirements
TFB 500 (SHV): Input impedance 50 Ω, output impedance 50 Ω,
Attenuation ratio: 500 : 1
TFB 1000 (SHV): Input impedance
1000 Ω, output impedance 50 Ω,
Attenuation ratio:1000 : 1
High voltage RF connector: SHV-BNC-JJ
BNC to Banana Plug: BNC (K) -2BP (J)
RF cable: 2*BNC/J-142-PNR-1000mm

3

Capacitive Coupling Clamp

Satisfy the technical requirements for capacitive coupling clamps in IEC61000-4-4, and conduct EFT/Burst anti-interference tests on the input, output, control, and data lines of the tested equipment by superimposing interference.
Model: CCC 100(SHV)