More
The power leads spike pulse generator TPS-CS106 which designed as per CS106 in MIL-STD-461F, GJB 151A-1997, GJB 152A-1997
The S10C20 is surge impulse current intelligent multi-functional generator, which is designed on the basis of the 3rd generation platform of our company.
The DMS 200 conducted, differential mode disturbances simulator is controlled by CoreLab control software, which is capable of conducting tests as per IEC 61000-4-19
The CM 0302M is used for measuring alternating current and time domain pulse current in the frequency range from 5 Hz to 2 MHz.
The EVPG 20 is designed as per EHV-10 (load dump with rapid rate of change) and EHV-16 HV pulse specified in VW 80300:2016
The CDN 405T8 is designed to conduct surge test on 4-pair-8-line unshielded symmetric high-speed communication lines for data transmission rate up to 1,000 MBit/s.
The WCT 20 is used in conducted, differential mode current test as per IEC 61000-4-19. It is capable of realizing electric isolation between differential-mode signal generator and EUT to ensure test safety.
Low-k dielectric material for laboratory test adopts material with dielectric constant (εr) less than or equal to 1.4.
The INS 800 high-frequency noise simulator is designed to simulate the interference generated when the relay is turned on or off as a representative of the inductive component.
The LISN AR 50 is designed as per section 20 and 22 in RTCA / DO 160 and used to standardize the impedance of the power source that provides input power for the EUT(s).
Youtube
Facebook
Twitter
